Get NYSERDA & utility offers| Free visual energy audit| Call (484) 989-7314

Blown-In Attic Insulation

Loose fill that flows around joists, wiring and framing to build one continuous blanket.

Free visual energy audit Written estimate before work starts Independent local contractors Evenings and weekends, no surcharge

Blown-In Attic Insulation

What it is, and when it is the right call

The attic floor is where most homes lose the most energy, and it is also the cheapest place to fix. Blown-in loose fill flows around joists, wiring runs, bracing and every awkward corner that batt insulation has to be cut around, which is exactly where batt installations leak.

Loose fill insulation blown evenly across an attic floor between the joists

What you get

It fills what batts cannot

A batt has to be cut to fit. Every cut is an approximation, and every approximation leaves a gap. Loose fill has no such problem: it settles into the space it is blown into, including the narrow bays along the eaves and the awkward triangles around chimneys and vents.

Depth you can verify

Installation is to a measured depth, with depth rulers left in the attic, so coverage is checkable rather than just claimed. You can go up and read it yourself, which is more than most installations give you.

Cost-effective per R-value

Per R-value installed, attic loose fill is usually the lowest-cost insulation upgrade available to a homeowner, and it is the one with the fastest payback in both heating and cooling climates.

Fast and clean

A typical attic is done in a few hours. The material is blown through a hose from the truck, so almost nothing is carried through your living space. The route is covered and cleaned up when the job is done.

Air seal first

Insulation slows heat; it does not stop air. Sealing the attic floor penetrations before adding depth is the usual order, because loose fill laid over open top plates and recessed light housings is insulating a hole.

Where it is available

Blown-In Attic Insulation across all three metros this site covers. Climate changes the specification, so the scope is not the same in Buffalo as it is in Phoenix.

Western New York

Climate Zone 5A and 6A. Typical target: R-49 to R-60 in the attic.

See all 11

Las Vegas Valley

Climate Zone 3B, hot and dry. Typical target: R-38 to R-49 in the attic.

See all 15

Phoenix Metro

Climate Zone 2B, hot and dry. Typical target: R-38 to R-49 in the attic.

See all 5

Current offers

Specials and discounts

Current specials. Call (484) 989-7314 with any questions, and mention the offer when you book.

Visual Energy Audit

Free

Energy audit, visual inspection and assessment. Attics, floors, walls, radiant barriers and more.

Valid for a limited time. Call for details.

Any Insulation Service

$75 OFF

Any insulation service over $475.00.

Valid for a limited time. Cannot be combined with other offers.

Attic Tent Special

$200

Attic tent supplied and installed, when installed together with attic insulation.

Valid for a limited time. Call for details.

R-38 Blown Insulation

$1,050

Furnish and install blown insulation to R-38, up to 1,200 sq. ft.

Valid for a limited time. Larger areas quoted on assessment.

Call to claim an offer

Frequently asked questions

How much insulation should my attic have?

It depends on your climate zone. Around Buffalo and Rochester the target is typically R-49 to R-60. In Las Vegas and Phoenix, R-38 to R-49 is the usual range. An on-site assessment measures what you have and tells you the gap.

Can blown-in go over existing insulation?

In most cases yes, as long as the existing material is dry and not contaminated. If it is wet, moldy or rodent-damaged it needs to come out first, and the contractor should say so before quoting.

Will blown-in insulation settle over time?

Some settling is normal and is accounted for in the installed depth. Proper installation follows the manufacturer coverage chart for the rated R-value, not just a depth that looks about right.

Does it make a mess in my house?

No. The material goes through a hose from the truck into the attic. The access route is protected and cleaned up before the contractor leaves.

Free estimate

Get your free visual energy audit

Call and tell us about the house. We connect you with an independent local contractor who inspects the attic, the accessible walls, the rim joist and the crawl space, then gives you a written picture of what is deficient and what each fix would change. No charge for that introduction, and no obligation.

  • Written estimate with scope, materials and R-values before any work begins
  • You are told if the house does not need the work yet
  • Evening and weekend appointments at no extra charge

Book by phone

One call starts the introduction. Tell us the address and what you are noticing, and we will connect you with an independent local contractor for a free audit.

Call (484) 989-7314

Monday to Friday 7:00am - 7:00pm, Saturday 8:00am - 4:00pm.

Need blown-in attic insulation?

Free visual energy audit, written estimate before any work begins, and evening or weekend appointments at no extra charge.