The USA Premium Injection Foam Installation Process
No surprises on the day. Here is exactly what happens, in order, from the first call through to the walkthrough at the end.
Premium Injection Foam
The Installation Process
No surprises on the day. Here is exactly what happens, in order, from the first call through to the walkthrough at the end.

Step by step
Assessment and consultation
The contractor inspects the walls, confirms the construction type, and finds out what is actually in the cavities. You get a written estimate with the scope, the materials and the timeline before anything is booked.
Preparation
The work area, the landscaping and the floors are protected. Access points are agreed with you, and power and water are confirmed.
Access points
Small holes are drilled into each stud bay, either from outside through the siding or from inside, depending on the construction. Siding courses are removed and replaced where that is the cleaner route.
Injection
Foam is injected under low pressure into each cavity, from the bottom up, so it fills completely and does not bridge over a void.
Monitoring and quality control
The installer checks fill at each bay as the work progresses rather than at the end, because a missed bay is far cheaper to catch while the equipment is still on the wall.
Post-installation inspection
Every bay is re-checked for complete fill, including around windows, doors and corners, which is where incomplete jobs usually show up.
Cleanup and restoration
Access points are patched, siding is reinstalled, and the site is cleaned. The exterior is left the way it was found.
Walkthrough
The contractor walks the job with you, explains what was done, hands over the paperwork, and answers anything outstanding before leaving. Ask what warranty, if any, the contractor provides. This site does not warrant the work.
Frequently asked questions
How long does the whole process take?
Most single-family homes are completed in one day. The assessment happens beforehand, so installation day is installation only.
Do I need to be home during the installation?
Someone should be available at the start and for the closing walkthrough. You do not need to be present for the full day.
What happens to the holes afterwards?
They are patched, and where siding was removed it is reinstalled. On most homes the access points are not visible once the contractor leaves.
Will the work damage my landscaping?
Plantings and beds should be protected before starting. Anything that has to be moved gets put back.
Free estimate
Get your free visual energy audit
Call and tell us about the house. We connect you with an independent local contractor who inspects the attic, the accessible walls, the rim joist and the crawl space, then gives you a written picture of what is deficient and what each fix would change. No charge for that introduction, and no obligation.
- Written estimate with scope, materials and R-values before any work begins
- You are told if the house does not need the work yet
- Evening and weekend appointments at no extra charge
Book by phone
One call starts the introduction. Tell us the address and what you are noticing, and we will connect you with an independent local contractor for a free audit.
Monday to Friday 7:00am - 7:00pm, Saturday 8:00am - 4:00pm.
Ready for a house that holds its temperature?
Free visual energy audit, written estimate before any work begins, and evening or weekend appointments at no extra charge.